Skip to content

Posts tagged ‘Seconds Mark’

Identifying Royal Copenhagen & Other Danish Factory Seconds

Identifying Royal Copenhagen & Other Danish Factory Seconds

It is important to know if you are spending a lot of money on a piece of Royal Copenhagen if it is a factory FIRST, or factory SECOND as often the appearance of the piece will often give no indication of it being a second. Any pieces coming out of the Royal Copenhagen (and Alumina) factories which did not meet the standard for perfection are marked as “seconds”.

This was done by etching a very fine short line, through the 3 Royal Copenhagen lines with a diamond cuter. A second mark will usually mean that the piece is worth less depending on the rarity and popularity of the piece, as seconds were sold at a 25-30% discount at the factory shop.

The pieces I come across most often marked as seconds are those from the 1950s and 1960s from the Tenera and Baca series under the direction of Nils Thorsson. Some designs in these series were inconsistent in how they fired in the kiln – and if too far from the desired look, they were marked as seconds and sold in the factory outlets. In other cases pieces could be marked as seconds because of tiny firing cracks (figurines mainly) or other small faults. However sometimes there seems to be nothing at all to indicate why it is a second.

Often this marking is invisible to the naked eye unless it catches the light, so with every piece of Royal Copenhagen it is best to run a finger over the back stamp, and you will feel immediately if the piece has been marked as second quality.  Sometimes the fault is visible, sometimes not.

The second marks are very hard to photograph because they are usually so fine – but you should be able to make them out in the images below: Read more